FishExplorer has been updated. See what's new... (hide this)
12.08.24 12:17 PM
I have a friend asking me my advise on purchasing a drill for his ice auger. I suggested either a DeWalt or a Milwaukee as I think both would do the job fine. I have a Milwaukee M18 Fuel/Clam Plate/ Nills I have been using for quite sometime and am very happy with its performance. My Milwaukee is a ... Log in to view rest of post...
12.08.24 1:10 PM
No need for a hammer drill, unless you are going to be needing a hammer drill in the off season. I l ... Log in to view...
hide replies
12.08.24 1:51 PM
B.T.W. My Niles shaft and the Clam conversion plate are not a tight fit and I had my machinist make ... Log in to view...
12.08.24 3:20 PM
12.08.24 3:20 PM
My Nils is 8". I found a sleeve on eBay that fits over the shaft of both. ... Log in to view...
12.08.24 3:01 PM
12.08.24 3:01 PM
Either one will work. You do not need the hammer drill function to run the auger. In fact it's hard ... Log in to view...